TIAO USB Multi-Protocol Adapter Lite (JTAG, SPI, I2C, Serial)

This TIAO USB Multi-Protocol adapter is powered by FTDI's flagship communication chip FT232H.

It supports the following protocols: JTAG, SPI, I2C and serial. 

This board can support voltage from 3.3v to 5.0v.

Supported softwares:

• Openocd
• Urjtag
• FlashRom
• jtag pro
• zJTAG - Windows console JTAG application to debrick wireless routers
• XC3SPROG - Windows / Linux console application to program CPLD/FPGA

Package Content: 

• TIAO USB Multi-Protocol Adapter Lite
• Dual Row 2x40 pin 2.54mm header (3 PCS, headers are NOT presoldered on the board)
• Female to Female Solderless Flexible JTAG Jumper Cable Wires (Length: 20cm, 8 PCS)

Technical Specificatons:

• USB 2.0 Hi-Speed (480Mb/s)
• JTAG / IEEE 1149.1 compatible.
• JTAG Baudrate up to 30Mbits/sec (programmable)
• JTAG signals are 5V to 3.3V tolerant
• ARM Muli-ICE 20-pin header compatible.
• Separate SPI/I2C/Serial interfaces
• 4 on-board LEDs / PWR, ext PWR, TX and RX
• 1 2x10 20 PIN JTAG header
• 1 2x3 6 PIN SPI 2.54mm IDC header
• USB Hot-Plug / JTAG Hot-Plug.
• USB over-current protection via on-board resetable fuse.
• Strong ESD protection on USB signals.
• Based on the FTDI FT232H USB device.
• Designed for FTDI MPSSE easy-to-use.
• Free drivers for Linux.
• Free drivers for Windows XP, Windows Vista and Windows 7/10 * Support both 32 bit and 64 bit operating systems
• Board dimension: 76.1mm X 48.6mm

You can use this USB based multi-protocol adapter lite to JTAG your router, cable modem or any JTAG/SPI devices. Fo

Manual

Driver